Marke / Kategorie: Bondtech
700 mm, Dupont cable 4-pin connector with locking function to JST-XH6 6-pin connector.
This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the schematics for your application.
Controller side Motor side
PIN 1 —————– PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 3
PIN 4 —————– PIN 6
If it is going to be used with our 25 mm Pancake motor then swap position of the two center wires in order to have a correct connection like below.
Controller side Motor side
PIN 1 —————– PIN 1
PIN 2 —————– PIN 3
PIN 3 —————– PIN 4
PIN 4 —————– PIN 6
| Dimensions | 70 cm |
|---|
Kaufe dir diesen Bondtech Extruder Mini für deinen Wanhao i3.
Bondtech Mini mit Dual-Drive-Filament-Förderung, die das Filament von beiden Seiten ohne Schlupf oder Schleifen einzieht, als ...
The LGX™ For Flexibles Set includes a reversible heat sink that can be installed on the left or right hand side of the cold block. The heat sink also includes the hole pattern for attaching 40×40 ...
Weight: 406g
Max Input current: 1.2A
Step angle: 1.8 deg.
Gear ratio: 5.18:1
Outputshaft diameter: 8.0 mm
Hole circle for mounting: 28 mm, 4xM3
Motor lenght: 40mm
4 verschiedene Einheiten verfügbar. Standard- (rechtshändig) und gespiegelte (linkshändig) Ausrichtung, sowohl für 3,00/2,85 und 1,75 mm Filamentdurchmesser.
Die Gehäuseteile sind ...