BondTech Drivegear Kit 2-85-3-0 mm - 8 mm

Marke / Kategorie: Bondtech

These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.

Gear set for filament size 2.85 - 3.0 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4 x 22 mm shaft.

A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.

- BondTech Drivegear Kit 2-85-3-0 mm - 8 mm ist ein Artikel vom Anbieter buw. Hersteller Bondtech.

Weiteres aus Bondtech

BondTech Nema17 Pancake Stepper 25 mm

Max Input current: 0.7A per phase
Step angle: 1.8 deg.
Torque: 18 Ncm
Outputshaft diameter: 5.0 mm
Hole for mounting: 31 mm, 4xM3
Motor lenght: 25mm

BondTech DDX v3 Adapter Set For Creality CR-10S Pro - Max

The DDX v3 is much easier to install

With the integrated fan shroud and mount included in the DDX v3 adapter sets, the DDX v3 is even easier to install. Snap the fan to the shroud without using screws. Adjust the ...

BondTech Drivegear Kit 1-75 mm - 8 mm

These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.

Gear set for filament size 1.75 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 ...

BondTech DualDirect Extruder-Upgrade für Raise3D

Kaufe dir diesen BondTech DualDirect Extruder-Upgrade für deinen Raise3D.

Dieses neue kompakte, leichte Extruder-Upgrade für deinen Raise3D-Drucker wird deine Zuführprobleme lösen, die ...