Marke / Kategorie: Bondtech
Die Halterung wird zwischen dem Motor und dem hinteren Gehäuse des Extruders geklemmt. Sie kann in 90-Grad-Schritten gedreht werden, um den Extruder nach deinen Bedürfnissen zu montieren. Die Montagebohrungen im unteren Flansch haben einen Durchmesser von 4,2 mm. vertikal 18,0 mm, horizontal 50,0 mm.
- BondTech BMG ALU-Mount ist ein Artikel vom Anbieter buw. Hersteller Bondtech.
The LGX™ For Flexibles Set includes a reversible heat sink that can be installed on the left or right hand side of the cold block. The heat sink also includes the hole pattern for attaching 40×40 ...
This extruder upgrade kit for the Ultimaker printers replaces the original feeder, it comes with it´s own Nema17 high precision geared steppermotor.
It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the ...
700 mm, Dupont cable 4-pin connector with locking function to JST-XH6 6-pin connector.
This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the ...
17 teeth gear in brass with M3x3 setscrew used in our BMG, Single and Dualdirect extruders.
Please make sure that the setscrew does not collide with the secondary plastic gear when assembled.